PB Systems
MERCURY SR2

Features

16 outputs
High-performance battery backer with high continuous load capacity
OLED screen, legible in sunlight
Bi-lingual menu system
Consistent duplication of all power electronics
Redundant electronic switch
Servo matching for all 16 outputs
Auto matching function
Door sequencer with Setup Assistant
The latest integrated iGyro technology, using the iGyroSAT as gyro sensor
9 independent gyro outputs for: 3x aileron, 3x elevator, 3x rudder
Two selectable output voltages: 6.0 V or 7.8 V
Optional GPS III for speed-dependent gyro compensation
Telemetry data for PowerBox P²BUS, Futaba S.BUS2, Jeti Ex-BUS, Spektrum SRXL2, Multiplex M-Link, JR X-BUS and Graupner HoTT
Transmission of battery, receiver and GPS* data
Virtually all features can be controlled from PowerBox and Jeti transmitters
Selectable servo frame rate: 12ms, 14ms, 16ms, 18ms
Servo feedback current suppression


Technical Data
Operating voltage 4.0V - 9.0V
Power supply 2S LiPo, 2S LiIon, 2S LiFePo, 5S NiCd/NiMH
Current drain Power-on state 100mA
Current drain Standby 30µA
Maximum load current 2 x 20A (<30s)
Drop-out voltage 0.3V
Output voltage 6.0V, 7.8V
Signal input serial
Supported RC systems PowerBox, Futaba, Jeti, Spektrum, M-Link and Hott
Receiver redundancy SRS
Channels 26
Servo sockets 16
Programmable servo outputs 16
Servo signal resolution 0,25µs
Signal frame rate 12ms, 14ms, 16ms, 18ms
Gyro sensor type external iGyro SAT
Number of sensor axes 9
Screen OLED 128x64 pixels
Integral door sequencer yes
Supported telemetry systems P²BUS, S.BUS2, EX-Tele, SRXL2, M-Link, Hott, X.BUS
Dimensions 89 x 54 x 19 mm
Weight 75g
Weight Sensor Switch 15g
Weight of LCD screen 34g
Temperature range -30°C to +105°C
less