PB Systèmes
PowerBox Mercury SRS GPS

499,00 €

Integral iGyro: Triple-axis gyro system with attitude assist function
Expanded setup assistant for ultra-simple operation
Special regulatory algorithm for fixed-wing model aircraft
Six independent gyro outputs for: 2x ailerons, 2x elevators, 2x rudders
Special thrust vector support
GPS-regulated gyro gain
Extremely accurate six-axis MEMS sensor
Integral Delta and V-tail mixer
Door sequencer: freely programmable outputs with set-up assistant
Servo-Match function: servo centre, end-points and reverse for all 15 servo outputs

SRS: Serial Receiver System provides the facility to use receivers with serial interface: Futaba S-Bus, Spektrum DSM2 und DSMX, Jeti UDI, Multiplex M-Link, HoTT and JR X-BUS
Unrestricted channel assignment for all 15 PowerBox outputs
Graphic OLED screen with 128 x 64 pixels
Extremely user-friendly menu-based programming using the SensorSwitch
15 channels
Signal amplification and interference suppression for all 15 outputs
Flight recorder, recording of lost frames and fail-safe events
Variable frame rate, range 12ms – 21ms
16-bit processors for fast, high-resolution signal processing
Double-regulated output voltages for receivers and servos
regulated output voltage 5.9V or 7.4V
Connection facilities for Futaba, Jeti, Spektrum, HoTT, JR and Multiplex MSB downlink bus systems
Direct transmission of the battery informations, receiver data and GPS data to the transmitter
Separate voltage display for each battery
Minimum value memory alerts the user to voltage collapses
Large-area heat-sinks for high regulator performance
Regulator monitoring, regulator error indicator
Support for three battery types: LiPo/LiIon, NiMh/NiCd, LiFePo
Suppression of any servo feedback currents which may occur
Updateable with PowerBox Systems USB Interface or BlueCom adapter

Technical Data
Operating voltage 4.0V - 9.0V
Power supply 2S LiPo/LiIon, 2S LiFePo, 5S NiCd/NiMH
Current drain Power-on state 99mA (with OLED)
Current drain Standby 3µA
Maximum load current Peak 2x20A
Drop-out voltage 0.3V
Output voltage 5.9V or 7.4V regulated
Signal input serial
Supported RC systems Jeti, Futaba, Spektrum, HoTT, M-Link, JR Propo
Receiver redundancy SRS
Channels 15 (18)
Servo sockets 15
Programmable servo outputs 15
Servo signal resolution 0.5µs
Signal frame rate 12ms, 15ms, 18ms, 21ms
Integral gyro system iGyro
Gyro regulation Attitude assist and Normalmode
Gyro sensor type MEMS
Number of sensor axes 6
Screen OLED
Integral door sequencer yes
Supported telemetry systems Jeti, Futaba, Spektrum, HoTT, M-Link, JR Propo
Dimensions 93 x 67 x 19 mm
Weight 85g
Weight Sensor Switch 15g
Weight of LCD screen 15g
Temperature range -30°C bis +75°C

Set contents

PowerBox Mercury SRS
3 Patchwires 3-pole, 200mm
8 mounting screws
Operating instructions

Optional: GPS Sensor (Order No.: 4110)
N° de réf.: PB4110